Hi @sacusa, I would recommend searching the Xilinx Forums on this since we haven't encountered this usage scenario yet. There should be lots of...
Hello @sacusa, .bmm is not needed for creating flash images. It is only required for merging .elf program files into the bitstream (.bit) files....
Hello @sacusa, Please take a look at this article:...
Hello @Vu Quang Huy, That is great news! :) Congratulations! It would also be really awesome if you have any article or blog post on your blog...
Hello @Vu Quang Huy, The JTAG on Channel A of FT2232H cannot be used directly with Vivado at the moment. But, you can use xc3sprog and openocd to...
Hi @MacGab997 , Glad that you were able to unbrick ElbertV2 with some really cool hacks! And yep, for other ElbertV2 owners, please do not use...
Hi @Alejandro Lopez, Issue here is that, Bitstream file can only contain the BRAM data which makes sense since it is not possible to fit, for...
Hi I.deoro, It sounds like hardware issue. Could you please send a mail to [email protected] mentioning the above details. Sending the mail will...
Hi I.deoro, We tested your .bin file and it is working fine. The behaviour of LED which you have mentioned is correct. During power, the FPGA...
Hi I.deoro, Could you also send your .bin file so that we can test whether it is working here or not. Also, picture of your neso board when...
Hi I.deoro, Could you please post some screenshots of the Configuration Utility and the verilog design + xdc file which you are using. The...
Hi Vu Quang, It's good to know that you were able to finally read and write the SPI flash! As for the ideas on increasing the speed,...
Hi Vu Quang, Please check out this excellent open source tool by [amilkovich] which supports reading/writing Saturn, Neso and Skoll flash. You...
Hi @mihnen There might be specific problem with the Saturn which you have. Could you please open a service ticket by mailing to [email protected]?...
Hi @mihnen , Can you please check with this variant of the Saturn Configuration, and report whether it works or not. Jumpers should be in SPI...
@Andrey, Can you please raise a ticket by mailing at [email protected] ? It will get to our support staff and they will help you. Thanks!
Hi @omstation, Glad it's working for you now! As for the making the bitstream "non-volatile" you can follow these steps under "Programming SPI...
Hi @Alexander Lang Thanks so much for your help and testing! About the sample code, our internal testing department regularly use the the same...
Hi @omstation, Thanks for the project. We slightly modified that and it's working now (project named `buffer`). There is also a NOT gate project...
Hello @skyfall_133 Assuming the hardware connections and power supply are correct, and also constraints are correct, then the only plausible...
Separate names with a comma.