1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

8 Channel USB Relay Module questions

Discussion in 'Relay Modules' started by Zach Hershberger, Sep 19, 2016.

  1. Zach Hershberger

    Zach Hershberger New Member

    Joined:
    Sep 19, 2016
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Location:
    USA
    I have a question about the 8 Channel USB Relay Module.

    A few things I have done so far:
    Plugged the module into my computer using a USB A to B cable.
    Installed the drivers found on Numato.
    Connected to device using PuTTY.
    Ran sample commands ver which came back with 00000008.
    Also I was able to turn relays off and on using 'relay off X' and 'relay on X' (X being the relay number).
    Read the status of the relays using 'relay read X'

    I noticed that there was no noise being exerted from the relay's which is kind of strange, is that normal?

    Also, I noticed the relay LED indicators are not lighting up. At least I thought they were LED's.
     
  2. Zach Hershberger

    Zach Hershberger New Member

    Joined:
    Sep 19, 2016
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Location:
    USA
    My 12VDC power supply was faulty. I replace the power supply and everything works.
     

Share This Page