[Resolved] Issues with Configuration of Mimas V2

Hi all,

I could able to program the FPGA with sample.bin file provided in the numato website.
But when i tried to program the FPGA with our logic even with simple logic forcing the values for LED port still it not reflecting in the hardware. i .e LED's are not glowing.

I doubt FPGA is configuring correctly except with sample.bin
what might gone wrong since i am not able to turn on/Toggle the LEDs but demo program runs fine

Thanks in Advance

 

I am newbie too but I was able to blink LED on my mimas V2,
https://docs.numato.com/kb/learning-fpga-verilog-beginners-guide-part-1-introduction/ this is the link which has a good tutorial and i did as it says so try this one may be it could help you!