1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Mimas External Power Specification

Discussion in 'FPGA Boards' started by Gary, Oct 1, 2015.

  1. Gary

    Gary New Member

    Joined:
    Oct 1, 2015
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    USA
    Can +12V be used to power Mimas on the Vext pins?
     
  2. admin

    admin Administrator Staff Member

    Joined:
    Jan 23, 2015
    Messages:
    169
    Likes Received:
    11
    Trophy Points:
    18
    Hi Gary,

    It is technically possible to use +12V at the external power input on Mimas. But I would carefully monitor the temperature of the LM317 LDO regulators. LDOs can warm up quite a bit with increase in input voltage. Using a fan is recommended if the regulators warms up too much.

    Thanks,
    Tom
     

Share This Page