1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Square Wave from 4 Channel USB Relay Module

Discussion in 'Relay Modules' started by Erin Hannan, Jul 17, 2016.

  1. Erin Hannan

    Erin Hannan New Member

    Joined:
    Jul 17, 2016
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Austin, TX
    Is it possible to generate a variable pulse signal of 0 - 10 kHz using the 4 Channel USB Relay Module?

    I am thought I would be able to control something with variable voltage from the GPIO, but I need 0 - 10V to achieve the full range.
     
  2. admin

    admin Administrator Staff Member

    Joined:
    Jan 23, 2015
    Messages:
    169
    Likes Received:
    11
    Trophy Points:
    18
    Hello Erin,

    It is not possible to generate 10KHz signal simply by toggling the GPIO. This is because USB CDC protocol implementation on this device cannot transport commands fast enough to toggle IOs at that rate.

    Thanks,
    Tom
    Numato Lab
     

Share This Page